LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - On Vehicle >> Shift Control Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the shift control knob. Refer to Transmission Control Lever Knob Replacement .
  2. Fig 1: Releasing The Remaining Boot Retaining Tabs
    GM180587Courtesy of GENERAL MOTORS CORP.
  3. Grasp the sides of the shift control boot and apply light pressure in toward the shift control lever to begin to release the shift boot retaining tabs from the instrument panel (I/P) accessory trim plate.
  4. Using light pressure, continue to release the remaining boot retaining tabs.
  5. Fig 2: View Of I/P Accessory Trim Plate & Boot
    GM71519Courtesy of GENERAL MOTORS CORP.
  6. Lift the boot away from the trim plate and remove the boot.
  7. Remove the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
  8. Fig 3: View Of Shift Control Closeout Boot & Retaining Nuts
    GM71524Courtesy of GENERAL MOTORS CORP.
  9. Remove the acoustic boot for the shiftier.
  10. Remove the shift control closeout boot retaining nuts.
  11. Remove the shift control closeout boot.
  12. Fig 4: View Of Shift Control Neutral Lock Pin
    GM180811Courtesy of GENERAL MOTORS CORP.
  13. Place the shiftier into NEUTRAL.
  14. Press down to engage the shift control neutral lock pin.
  15. Fig 5: View Of Transmission Shift Rod, Clamp & Bolt
    GM71526Courtesy of GENERAL MOTORS CORP.
  16. Remove the transmission shift rod clamp bolt.
  17. Remove the shift control mounting bolts.
  18. Raise the shift control to release the locator from the shiftier bracket on the side of the driveline support assembly.
  19. Release the shift control from the transmission shift rod clamp and remove the shift control assembly.