LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - Off Vehicle >> Transmission Disassemble >> Reverse Lockout Assembly Disassemble

Reverse Lockout Assembly Disassemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Disassembled View Of Reverse Lockout Assembly
    GM350562Courtesy of GENERAL MOTORS CORP.
    WARNING: The reverse lockout assembly is under spring pressure. Exercise caution when removing the retainer ring, as bodily injury may result.
  1. Remove the O-ring (8) from the body (1).
  2. Remove the retainer ring (7) from the body (1).
  3. Remove the reverse lockout inner spring (2).
  4. Compress the reverse lockout plunger (6) and the collar (4) in a vise and remove the retainer ring (3).
  5. Remove the reverse lockout plunger (6).
  6. Remove the reverse lockout outer spring (5).
  7. Remove the reverse lockout collar (4).
scientia non olet · About LEMON Manuals