LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions - Off Vehicle >> Transmission Assemble >> Reverse Lockout Assembly Assemble

Reverse Lockout Assembly Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Exploded View Of Reverse Lockout Assembly
    GM350562Courtesy of GENERAL MOTORS CORP.
    WARNING: The reverse lockout assembly is under spring pressure. Exercise caution when removing the retainer ring, as bodily injury may result.
  1. Install the reverse lockout plunger (6).
  2. Install the reverse lockout outer spring (5).
  3. Install the reverse lockout collar (4).
  4. Compress the reverse lockout plunger and the collar (4) in a vise and Install the retainer ring (3).
  5. Install the reverse lockout inner spring (2).
  6. Install the reverse lockout components in the body (1).
  7. Install the retainer ring (7).
  8. Install the O-ring to body (8).
scientia non olet · About LEMON Manuals