LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - TREMEC 6-Speed) >> Diagnostic Information and Procedures >> DTC P0803 >> Repair Verification

Repair Verification

WARNING: This page is about a different variant/trim than selected.
  1. Install any components or connectors that have been removed or replaced during diagnosis.
  2. Perform any adjustment, programming, or setup procedures that are required when a component or module is removed or replaced.
  3. Clear the DTCs.
  4. Turn OFF the ignition for 60 seconds.
  5. Engine running, command skip shift solenoid ON and OFF with a scan tool, while observing the skip shift circuit status parameters. The circuit status parameters should change from OK to Not Run or Not Run to OK.
scientia non olet · About LEMON Manuals