LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2009 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - TREMEC 6-Speed) >> Diagnostic Information and Procedures >> DTC P0803 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON, command the skip shift solenoid ON and OFF, with a scan tool, while observing the following skip shift circuit status parameters.
    • Skip shift solenoid control Ckt. Short Gnd Test Status
    • Skip shift solenoid control Ckt. Open Test Status
    • Skip shift solenoid control Ckt. Short Volts Test Status
    • Each parameter should toggle between OK and Not Run or Not Run and OK.
  2. Operate the vehicle within the Conditions for Running the DTC, to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals