Case Extension Bushing Replacement

Case Extension Bushing Replacement (2WD Truck/Utility/Van Only)


Tools Required
* J 8092 Driver Handle
* J 23062-14 Bushing Remover
* J 34196-B Transmission Bushing Service Set






1. Inspect the case extension for the following conditions:

* Porosity
* Cracks
* Nicks
* Burrs
* Worn bushings





2. Remove the case extension oil seal assembly (34) (model dependent).




3. Using the J 23062-14 and the J 8092 , remove the case extension bushing (33).




4. Using the J 34196-4 which is part of kit J 34196-B and the J 8092 , install a case extension bushing (33).