Auxiliary Blower Motor: Service and Repair

Auxiliary Blower Motor Replacement

Removal Procedure

1. Remove the instrument panel assembly.




2. Disconnect the electrical connectors (4) from the blower motor-auxiliary (3).
3. Remove the air outlet duct from the blower motor-auxiliary.
4. Remove the screws (2, 5) from the blower motor-auxiliary.
5. Remove the blower motor-auxiliary (3).

Installation Procedure




1. Install the blower motor-auxiliary (3).

Notice: Refer to Fastener Notice.

2. Install the retaining screws (2, 5) to the blower motor-auxiliary.

Tighten the screws to 10 N.m (88 lb in).

3. Install the air outlet duct to the blower motor-auxiliary.
4. Connect the electrical connectors (4) to the blower motor-auxiliary (3).
5. Install the instrument panel assembly.