Floor Air Outlet Duct Replacement - Left Side (with JF4)

Floor Air Outlet Duct Replacement - Left Side (with JF4)

Removal Procedure




1. Remove the instrument panel (I/P) carrier.
2. Remove the push pin (2) retaining the floor air outlet duct (1) to the heater module.
3. Remove the floor duct (1).

Installation Procedure




1. Install the floor air outlet duct (1) into position.

Notice: Refer to Fastener Notice.

2. Install the floor air outlet duct retaining push pin (2).

Tighten the screws to 1.9 N.m (17 lb in).

3. Install the I/P carrier.