LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Optra5 LT, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - AISIN 81-40LE - Service, Overhaul, Removal & Installation & Diagnosis >> Transmission Cooler Pipes and Hoses Replacement (Inlet) >> Removal Procedure

Removal Procedure

    NOTE: Refer to Vehicle Lifting and Jacking Notice .
  1. Raise and support the vehicle.
  2. Drain the transaxle fluid.
  3. Remove the clip from the hose, then disconnect the hose from the fluid cooler inlet pipe.
    4. Fig 1: Identifying Inlet Pipe Union Bolt
    GM1376110Courtesy of GENERAL MOTORS CORP.
  4. Remove the inlet pipe union bolt from the radiator.
    5. Fig 2: View Of Fluid Cooler Inlet Pipe, Bolt And Transaxle
    GM1245839Courtesy of GENERAL MOTORS CORP.
  5. Remove the fluid cooler inlet pipe bolt from the transaxle.
  6. Remove the inlet pipe fitting nut from the transaxle.
  7. Remove the fluid cooler inlet pipe and hoses.
scientia non olet · About LEMON Manuals