Installation Procedure

Fig 1: View Of Fluid Cooler Inlet Pipe, Bolt And Transaxle

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the fluid cooler inlet pipe fitting nut into the transaxle.
Tighten: Tighten the fluid cooler inlet pipe fitting nut to 35 N.m (26 lb ft) .
Install the fluid cooler inlet pipe bolt into the transaxle.
Tighten: Tighten the fluid cooler inlet pipe bolt to 9 N.m (80 lb in) .

Fig 2: Identifying Inlet Pipe Union Bolt

Courtesy of GENERAL MOTORS CORP.

Connect the fluid cooler hoses and install the clip into the radiator threaded connector.
Lower the vehicle.
Fill the transaxle with the fluid.