LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Optra5 LS, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Drum Brakes >> Repair Instructions >> Rear Brake Backing Plate Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. If equipped with an anti-lock brake system (ABS), disconnect the connector from the wheel speed sensor.
  3. Remove the brake shoe components. Refer to Brake Shoe Replacement .
  4. Remove the park brake cable and the retainer. Remove the cable from the brake shoe lever. Refer to Park Brake Cable Replacement .
    5. Fig 1: View Of Wheel Cylinder Assembly And Brake Line
    GM1245741Courtesy of GENERAL MOTORS CORP.
  5. Remove the brake line from the backing plate and plug the opening in the line to prevent fluid loss or contamination.
  6. Remove the wheel cylinder assembly. Refer to Wheel Cylinder Replacement .
    7. Fig 2: View Of Wheel Hub Backing Plate Bolts
    GM1506523Courtesy of GENERAL MOTORS CORP.
  7. Remove the bolts that secure the wheel hub assembly to the backing plate.
  8. Remove the wheel hub assembly.
  9. Remove the backing plate and the gasket.
scientia non olet · About LEMON Manuals