Removal Procedure
- Disconnect the negative battery cable.
- Move the gear select lever to the Park position.
- Remove the battery.
- Install J 28467-B (1).
- Disconnect the transaxle wiring harness from the transaxle.
- Disconnect the electrical connector from the park/neutral position (PNP) switch.
- Remove the clips from the shift control cable and disconnect the cable from the transaxle.
- Remove the bolts that secure the upper transaxle to the engine.
- Remove the left transaxle mounting bracket. Refer to Transmission Mount Bracket Replacement .
- Raise and suitably support the vehicle. Refer to Vehicle Lifting and Jacking Notice .
- Drain the transaxle fluid.
- Remove the oil cooler pipes from the transaxle. Refer to Transmission Fluid Cooler Hose/Pipe Replacement .
- Remove the drive axle. Refer to Wheel Drive Shaft Replacement (Diesel - Automatic and Manual) or Wheel Drive Shaft Replacement (Gasoline - Automatic Transaxle) or Wheel Drive Shaft Replacement (Gasoline - Manual Transaxle) .
- Remove the starter motor. Refer to Starter Motor Replacement (1.4L/1.6L) or Starter Motor Replacement (1.8L/2.0L) or Starter Motor Replacement (2.0L Diesel) .
- Remove the rubber access cover from the transaxle, then remove the flywheel to torque converter bolts.
- Support the transaxle.
- Remove the bolts from the rear transaxle mounting bracket.
- Remove the bolt and nut from the damping block connection.
- Use DW 260-010 (1) to support the transaxle assembly.
- Remove the bolts that retain the lower engine to the transaxle.
- Using the DW 260-010 (1), remove the transaxle assembly.
CAUTION:
Refer to Battery Disconnect Caution
.