Installation Procedure

Fig 1: Identifying Inlet Pipes

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the inlet pipe assembly and the assembly bolts.
Tighten: Tighten the inlet pipe bolts to 35 N.m (26 lb ft) .

Fig 2: Identifying Outlet Pipes

Courtesy of GENERAL MOTORS CORP.

Install the outlet pipe assembly and the assembly bolts.
Tighten: Tighten the outlet pipe bolts to 35 N.m (26 lb ft) .
Refill the transaxle fluid. Refer to Transmission Fluid Draining .
Install the engine cover. Refer to Engine Cover Replacement .
Connect the negative battery cable.