Test Steps
Perform the general procedures according to the automatic transaxle diagnostic procedure:
- Test drive
- Inspect the oil level and quality
- Interrogate fault memory
| Condition | Action |
|---|---|
| Defective clutch in the transaxle if no Drive gear is available with the TCM disconnected | This condition is usually due to too little oil being added, or to internal damage. Repair is not possible. If necessary, exchange the transaxle. |
| The kick down switch is not functioning properly | For checking and remedial action. Refer to Drive Range - Fourth Gear, Emergency/Substitute Mode or Drive Range - Third Gear, Emergency/Substitute Mode . |
| The vehicle is in Emergency mode. | For checking and remedial action. Refer to Drive Range - Fourth Gear, Emergency/Substitute Mode or Drive Range - Third Gear, Emergency/Substitute Mode . |