Automatic Transmission Fluid Pan and Gasket Installation: Installation
- Install the oil pan and the oil pan gasket and the bolts.
Tighten: Tighten the bolts to 6 N.m (53 lb in) .
- Install the oil cooler inlet and outlet pipes. Refer to Transmission Fluid Cooler Hose/Pipe Replacement .
- Use DT 46475 (1) to install the transaxle fluid drain plug. See Special Tools .
- Install the engine cover. Refer to Engine Cover Replacement .
- Refill the transaxle fluid. Refer to Transmission Fluid Level Inspection .
- Connect the negative battery cable.
NOTE:
Refer to Fastener Notice
.