LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Optra LT, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - AISIN 81-40LE - Service, Overhaul, Removal & Installation & Diagnosis >> Park/Neutral Position Switch Adjustment >> Removal Procedure

Removal Procedure

    Fig 1: View Of PNP Switch Electrical Connector And Wiring Harness
    GM1245819Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution .
  1. Disconnect the negative battery cable.
  2. Disconnect the park/neutral position (PNP) switch electrical connector from the wiring harness.
    3. Fig 2: View Of Shift Control Cable And PNP Switch Lever
    GM1245820Courtesy of GENERAL MOTORS CORP.
  3. Remove the E-ring.
  4. Disconnect the shift control cable from the PNP switch lever.
    5. Fig 3: View Of Retaining Nut, Washer And Control Lever
    GM1245823Courtesy of GENERAL MOTORS CORP.
  5. Remove the retaining nut and then remove the washer and the control lever.
  6. Using a driver, unstake the lock washer and remove the nut.
scientia non olet · About LEMON Manuals