Control Valve Body Assemble

Fig 1: View Of Valve Body Plate And Lower Valve Body

Courtesy of GENERAL MOTORS CORP.

Fig 2: View Of Upper Valve Body And Lower Valve Body

Courtesy of GENERAL MOTORS CORP.

Fig 3: View Of Valve Body And Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the 2 bolts to the valve body. The bolt lengths are 49 mm (1.93 in) (1) and the 36 mm (1.42 in) (2).
Tighten: Tighten the bolts to 11 N.m (97 lb in) .
Turn the valve body.

Fig 4: View Of Spring, Check Valve And Check Ball

Courtesy of GENERAL MOTORS CORP.

Install the check valve, spring, and check ball.
Install the ball, spring, spring seat, and bolt.
Tighten: Tighten the bolts to 6.5 N.m (57 lb in) .

Fig 5: View Of Control Valve Body, Cover, Gaskets And Plate

Courtesy of GENERAL MOTORS CORP.

Fig 6: View Of Control Valve Body And Bolts

Courtesy of GENERAL MOTORS CORP.

Tighten the bolts temporarily.
Tighten the bolts completely. The bolt lengths are 49 mm (1.93 in), 20 mm (0.79 in), and 60 mm (2.36 in).
Tighten: Tighten the bolts to 11 N.m (97 lb in) .

Fig 7: Identifying Shift Solenoid Valve Bolts

Courtesy of GENERAL MOTORS CORP.

Install the 5 shift solenoid valves with the 5 bolts (1). The bolt lengths are 49 mm (1.93 in) and 20 mm (0.79 in).
Tighten: Tighten the bolts to 11 N.m (97 lb in) .
Install the manual valve.

Fig 8: View Of Primary Regulator Valve

Courtesy of GENERAL MOTORS CORP.

Make sure that the primary regulator valve is positioned in the same place where it was removed.