LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions -- 4 Of 5)) >> Off-Vehicle Repair Instructions - Part 3 >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a NEW O-ring on the oil level indicator tube.
    2. Fig 1: Identifying Oil Level Indicator & Tube
    GM1395941Courtesy of GENERAL MOTORS CORP.
  2. Install the oil level indicator and tube by sliding the tube down through the lower crankcase hole.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the oil level indicator tube bracket bolt.

    Tighten:  Tighten the oil level indicator tube bracket bolt to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals