LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Engine Mount Strut Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Bolt & Nut For Engine Mount Strut At Engine Mount Strut Bracket On Upper Radiator Support
    GM61850Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount strut.
  2. Install the bolt and the nut to the engine mount strut at the engine mount strut bracket on the upper radiator support. HAND TIGHTEN ONLY.
    3. Fig 2: Left Engine Mount Strut
    GM1574576Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolt and the nut to the engine mount strut at the left engine mount strut bracket on the engine.

    Tighten:  Tighten bolt engine mount strut nuts to 48 N.m (35 lb ft).

scientia non olet · About LEMON Manuals