LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Engine Mount Strut Bracket Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the right engine mount strut bracket to the vehicle.
    2. Fig 1: Locating Engine Mount Strut Bracket Bolts
    GM1457532Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Connect the engine mount strut bracket bolts to the cylinder head.

    Tighten:  Tighten the engine mount strut bracket bolts to 50 N.m (37 lb ft).

  3. Install the generator into the proper position.
  4. Install the generator bolts.

    Tighten:  Tighten the generator bolts to 50 N.m (37 lb ft).

  5. Install the right engine mount strut and radiator support bracket to the right engine mount strut bracket. Refer to Engine Mount Strut Replacement - Right .
  6. Connect the pulley to the generator.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About LEMON Manuals