LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Drive Belt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the right engine splash shield. Refer to Splash Shield Replacement - Engine in Body Front End.
    3. Fig 1: View Of Drive Belt Tensioner
    GM1394083Courtesy of GENERAL MOTORS CORP.
  3. Rotate the drive belt tensioner clockwise to release the drive belt tension.
  4. Remove the drive belt from the generator.
  5. Slowly release the drive belt tensioner.
  6. Remove the drive belt from the accessory drive pulleys.
scientia non olet · About LEMON Manuals