LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Impala LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions -- 4 Of 5)) >> Off-Vehicle Repair Instructions - Part 3 >> Oil Pump Installation

Oil Pump Installation

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pump & Mounting Bolts
    GM902821Courtesy of GENERAL MOTORS CORP.
  1. Align the oil pump gerotor with the crankshaft flats and install the oil pump to the engine block.
  2. Align the pump body with the mounting holes in the cylinder block.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the oil pump bolts.

    Tighten:  Tighten the oil pump bolts to 23 N.m (17 lb ft).

scientia non olet · About LEMON Manuals