LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Impala LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions - 2 Of 5)) >> On-Vehicle Repair Instructions (Part 2) >> Oil Pan Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Assemble the oil pan as necessary.
    2. Fig 1: View Of Oil Pan
    GM1306202Courtesy of GENERAL MOTORS CORP.
  2. Install the oil pan.
  3. Loosen the engine support fixture wing nuts in order to lower the engine and engage the engine mounts to the frame.
  4. Remove the engine support fixture. Refer to Engine Support Fixture .
  5. Remove the transmission oil cooler pipe retainer from the engine right side.
  6. Fill the engine with new engine oil. Refer to Engine Oil and Oil Filter Replacement .
  7. Install the A/C compressor bracket with the A/C compressor.
    8. Fig 2: Identifying Frame Mounting Nuts
    GM785352Courtesy of GENERAL MOTORS CORP.
  8. Install the engine mount lower nuts.
    9. Fig 3: View Of Intermediate Steering Shaft
    GM754891Courtesy of GENERAL MOTORS CORP.
  9. Connect the intermediate steering shaft.
  10. Install the power steering hose retainer to the A/C compressor bracket.
  11. Install the engine front cover. Refer to Engine Front Cover Replacement .
scientia non olet · About LEMON Manuals