LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Impala LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions - 2 Of 5)) >> On-Vehicle Repair Instructions (Part 2) >> Engine Oil Pressure Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pressure Sender
    GM1210954Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the oil pressure sensor.

    Tighten:  Tighten the oil pressure sensor to 20 N.m (15 lb ft).

  2. Connect the oil pressure sensor electrical connector.
scientia non olet · About LEMON Manuals