LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Impala LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions - 2 Of 5)) >> Off-Vehicle Repair Instructions (Part 1) >> Crankshaft Balancer Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Tool EN 46106
    GM945978Courtesy of GENERAL MOTORS CORP.
  1. Install the EN 46106  through the starter mounting hole. See Special Tools .
    2. Fig 2: Identifying Crankshaft Balancer Bolt
    GM1395946Courtesy of GENERAL MOTORS CORP.
  2. Remove the crankshaft balancer bolt.
    3. Fig 3: View Of J 38416-2 In The Nose Of The Crankshaft
    GM1395949Courtesy of GENERAL MOTORS CORP.
  3. Install the J 38416-2  in the nose of the crankshaft. See Special Tools .
  4. Install the J 41816  in order to remove the crankshaft balancer. See Special Tools .
  5. Tighten the center bolt of the J 41816  in order to pull the crankshaft balancer off of the crankshaft. See Special Tools .
  6. Remove the J 41816  from the crankshaft balancer. See Special Tools .
scientia non olet · About LEMON Manuals