LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Impala LTZ >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Rear Side Door Conduit Replacement >> Removal Procedure

Removal Procedure

IMPORTANT: Mark the location and the color of the wires to the electrical socket before removing the wires.
    Fig 1: View Of Rear Door Wiring Harness
    GM459522Courtesy of GENERAL MOTORS CORP.
  1. Remove the conduit from the center pillar.
  2. Disconnect the rear door wiring harness electrical connector from the body harness.
  3. Disconnect the wire harness retainer from the wiring harness socket.
  4. Remove the wiring harness wiring one at a time from the socket.
  5. Remove the rubber conduit from the rear door.
  6. Remove the wiring harness wiring from the rubber conduit.
scientia non olet · About LEMON Manuals