LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> HHR SS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Vehicle Speed Sensor Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Refer to BATTERY DISCONNECT CAUTION .
  1. Disconnect the negative battery cable from the battery negative terminal.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the electrical connector at the vehicle speed sensor.
    4. Fig 1: Vehicle Speed Sensor (VSS) & Retaining Stud
    GM104524Courtesy of GENERAL MOTORS CORP.
  4. Remove the retaining stud and the sensor. Pull straight out in order to avoid damage to the case.
scientia non olet · About LEMON Manuals