LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> HHR SS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Park/Neutral Position Switch Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Identifying Shift Control Cable, Lever & Electrical Connector At Transaxle Range (TR) Switch
    GM1233683Courtesy of GENERAL MOTORS CORP.
  1. Apply the parking brake and place the control assembly in Neutral. The transaxle manual shaft must be in the Neutral position prior to installing the range switch.
  2. Remove the shift control cable from the transaxle range switch lever.
  3. Disconnect the electrical connector from the transaxle range switch.
    4. Fig 2: Identifying Transaxle Range (PNP) Switch Lever
    GM1233687Courtesy of GENERAL MOTORS CORP.
  4. Remove the transaxle range switch lever nut and lever.
    5. Fig 3: Identifying Transaxle Range Switch And Mounting Bolts
    GM1233691Courtesy of GENERAL MOTORS CORP.
  5. Remove the transaxle range switch bolts and remove the switch.
scientia non olet · About LEMON Manuals