LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> HHR SS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Floor Shift Control Knob Replacement >> Removal Procedure

Removal Procedure

    IMPORTANT: Place the shift control in NEUTRAL before attempting to remove the shift knob screw.
    Fig 1: Shift Knob Bezel
    GM1662976Courtesy of GENERAL MOTORS CORP.
  1. Pull the shift knob bezel (1) down to expose the shift knob retaining screw.
    2. Fig 2: Shift Knob Retaining Screw
    GM1662977Courtesy of GENERAL MOTORS CORP.
  2. Remove the shift knob retaining screw (1).
    3. Fig 3: Shift Knob & Bezel
    GM1662978Courtesy of GENERAL MOTORS CORP.
  3. Remove the shift knob (1) and bezel (2) from the shift control lever.
scientia non olet · About LEMON Manuals