LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> HHR SS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Floor Shift Control Knob Replacement >> Installation Procedure

Installation Procedure

    IMPORTANT: Place the shift control in NEUTRAL before attempting to install the shift knob screw.
    Fig 1: Shift Knob & Bezel
    GM1662978Courtesy of GENERAL MOTORS CORP.
  1. Install the bezel (2) and shift knob (1) to the shift control lever.
    2. NOTE: Refer to Fastener Notice .
    Fig 2: Shift Knob Retaining Screw
    GM1662979Courtesy of GENERAL MOTORS CORP.
  2. Install the shift knob retaining screw (1).

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

    3. Fig 3: Shift Knob Bezel
    GM1662980Courtesy of GENERAL MOTORS CORP.
  3. Secure the shift knob bezel (1) to the shift knob.
scientia non olet · About LEMON Manuals