LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> HHR SS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Control Valve Body Cover Gasket Replacement >> Removal Procedure

Removal Procedure

  1. Remove the transmission side cover. Refer to Control Valve Body Cover Replacement .
    2. Fig 1: Locating Components On Side Cover
    GM20822Courtesy of GENERAL MOTORS CORP.
  2. Remove the side cover gaskets (5 and 6) and the thrust washer (7) from the side cover (1).
  3. Inspect the side cover for cracks or damage to the seal grooves and mounting bosses.
  4. Inspect the side cover seals for damage. The side cover seals are reusable if not damaged.
  5. Thoroughly clean the side cover and the side cover seals. Clean and dry the seal grooves and the axle seal bore.
scientia non olet · About LEMON Manuals