LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> HHR SS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Reaction Internal Gear, Input Carrier Disassemble

Reaction Internal Gear, Input Carrier Disassemble

    Fig 1: Locating Input Carrier Assembly To Reaction Internal Gear
    GM20254Courtesy of GENERAL MOTORS CORP.
  1. Remove the thrust bearing (107) from the reaction carrier (562) if the thrust bearing has not been removed.
  2. Remove the reaction internal gear (560) to input carrier assembly snap ring (563).
    3. IMPORTANT: The reaction internal gear and the input internal gear are identical parts. However, these parts are not interchangeable after the transmission has operated in a vehicle.
  3. Remove the input carrier assembly (562) from the reaction internal gear (560).
scientia non olet · About LEMON Manuals