LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> HHR SS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Output Shaft Installation

Output Shaft Installation

    Fig 1: Installing Snap Ring On Final Drive End Of Output Shaft
    GM474281Courtesy of GENERAL MOTORS CORP.
  1. Install a new snap ring (57) into the snap ring groove on the final drive end (small machined diameter) of the output shaft (94).
  2. Install the output shaft (94) into the final drive assembly. Use a mallet in order to install the shaft (94) through the final drive differential gear.
    3. Fig 2: Installing Snap Ring Into Output Shaft Snap Ring Groove
    GM474279Courtesy of GENERAL MOTORS CORP.
  3. Install a new snap ring (57) into the output shaft snap ring groove.
scientia non olet · About LEMON Manuals