LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> HHR SS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Drive Sprocket Support Installation

Drive Sprocket Support Installation

    Fig 1: Inspecting Converter Seal Drain Holes For Blockage
    GM25500Courtesy of GENERAL MOTORS CORP.
  1. Inspect the drive sprocket support (43) for damage to the stator shaft splines, the journals, the bushings, and the roller bearing.
  2. Inspect the converter seal drain holes for blockage.
    3. Fig 2: Locating Drive Sprocket Support
    GM20213Courtesy of GENERAL MOTORS CORP.
  3. Install the drive sprocket support (43) into the bell housing of the transmission case.
  4. Install the six drive sprocket support bolts (53) into the drive sprocket support (43).
    5. NOTE: Refer to Fastener Notice .
  5. Hand start the bolts.

    Tighten:  Tighten the bolts to 12 N.m (9 lb ft).

scientia non olet · About LEMON Manuals