LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> HHR LS, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays & Gages >> Diagnostic Information and Procedures >> Fuel Gage Inaccurate or Inoperative >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the fuel level sensor.
  2. Ignition OFF, test for less than 1 ohm between the fuel level sensor low reference circuit terminal B and ground.
    • If greater than the specified range, test the circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Install a Signal Generator and Instrument Panel Tester between the fuel level sensor signal circuit terminal C and the low reference circuit terminal B.
  4. Ignition ON, vary the signal generator resistance between 40-250 ohms. Verify that the scan tool Fuel Tank Level Remaining parameter displays a range that varies between 5 and 95 percent as the signal generator resistance changes.
    • If not displaying the specified range, test the signal circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  5. Vary the signal generator resistance between 40 and 250 ohms. Verify that the fuel gage displays a range that varies between empty and full as the signal generator resistance changes.
    • If not displaying the specified range, replace the instrument panel cluster (IPC).
  6. If all circuits test normal, perform the fuel level sensor component test before replacing the fuel level sensor.
scientia non olet · About LEMON Manuals