LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> HHR LS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Front Mount Replacement >> Installation Procedure

Installation Procedure

    IMPORTANT: The transaxle bolts must be torqued in a mandatory sequence as shown.
    Fig 1: View Of Front Transaxle Mount
    GM1506918Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the front transaxle mount and transaxle bolts.

    Tighten:  Tighten the bolts to 90 N.m (66 lb ft).

    2. Fig 2: View Of Front Transaxle Mount Through Bolt
    GM1497621Courtesy of GENERAL MOTORS CORP.
  2. Hand tighten the front transaxle mount thru bolt.
    3. IMPORTANT: The front and rear transmission mounts must be allowed to settle with the thru bolts loosened.
  3. Loosen the rear trans mount thru bolt.
  4. Tighten the transmission mount thru bolts in the following order.

    Tighten: 

    1. Tighten the rear bolt to 100 N.m (74 lb ft).
    2. Tighten the front bolt to 100 N.m (74 lb ft).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals