LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> HHR LS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Park/Neutral Position Switch Replacement >> Installation Procedure (New Switch)

Installation Procedure (New Switch)

    Fig 1: Identifying Transaxle Range Switch And Mounting Bolts
    GM1233691Courtesy of GENERAL MOTORS CORP.
  1. Make sure the transaxle manual shaft is in the Neutral position.
  2. Align the flats on the transaxle shift shaft with the flats on the transaxle range switch and install the switch.
  3. Tighten the transaxle range switch bolts.

    Tighten:  Tighten the range switch bolts to 20 N.m (15 lb ft).

  4. Install the transaxle range switch lever and nut.

    Tighten:  Tighten the transaxle range switch lever retaining nut to 35 N.m (26 lb ft).

    5. Fig 2: Identifying Shift Control Cable, Lever & Electrical Connector At Transaxle Range (TR) Switch
    GM1233683Courtesy of GENERAL MOTORS CORP.
  5. Connect the transaxle range switch electrical connector.
    6. IMPORTANT: After adjusting the switch, verify the engine only starts in Park or Neutral. If the engine starts in any other position, adjust the switch.
  6. Install the shift control cable to transaxle range switch lever and verify proper operation.
scientia non olet · About LEMON Manuals