LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> HHR LS, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Intermediate/Fourth Servo Assembly Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Oil Filter, O-Ring Seal & Oil Level Control Valve
    GM893266Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the oil pan. Refer to Oil Pan Replacement .
  3. Remove the oil level control valve. Pull the valve straight down. Do not pry on the valve.
  4. Remove the oil filter and oil filter O-ring seal. The seal may stay in the case when the filter is removed.
    5. Fig 2: Removing Oil Filter Neck Seal
    GM893225Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not score or damage the transaxle case when removing the filter neck seal.
  5. Using a chisel, indent the top of the filter neck seal to relax the press fit.
  6. Remove the filter neck seal from the transaxle case and discard.
    7. Fig 3: Removing & Installing Intermediate/Fourth Servo Assembly
    GM893231Courtesy of GENERAL MOTORS CORP.
  7. Remove the intermediate/4th servo assembly bolts.
  8. Remove the intermediate/4th servo assembly.
scientia non olet · About LEMON Manuals