Instrument Cluster Scan Tool Information
Instrument Panel Cluster Scan Tool Data Parameters
| Parameter | System State | Expected Value | Description |
|---|---|---|---|
| Operating Conditions: Ignition ON | |||
| Battery Voltage Signal | - | Varies | This displays Volts. This is the current battery voltage signal. |
| DIC Information Switch | - | Inactive | The scan tool displays Active or Inactive. This is the state of the driver information center (DIC) information switch. |
| Ignition 1 Input | - | Active | The scan tool displays Active or Inactive. This is the state of the ignition 1 input. |
| Menu Switch | - | Off | The scan tool displays On or Off. This is the state of the menu switch. |
| Reset Switch | - | Inactive | The scan tool displays Active or Inactive. This is the state of the reset switch. |
Instrument Panel Cluster Scan Tool Output Controls
| Output Control | Description |
|---|---|
| Dimming | This output control is used to command the dimming to INCREASE or DECREASE by 20% increments. |
| IPC Gauge Sweep Test | This output control is used to command the gages to sweep from minimum to maximum. |
| Lamp Test | This output control is used to command the instrument panel indicators to turn ON and OFF. |