Rear Output Shaft Seal Replacement

Rear Output Shaft Seal Replacement

Tools Required

J 45756 Rear Output Shaft Seal Installer


Removal Procedure


Notice: Refer to Transfer Case Seal Removal Notice .





1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement (One-Piece Propeller Shaft Replacement) .
3. Remove the rear output shaft seal by prying it out with a flat tipped screwdriver.



Installation Procedure





1. Using J 45756 , install a new rear output shaft seal.
2. Install the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement (One-Piece Propeller Shaft Replacement) .
3. Check the fluid level. Add fluid, if necessary.
4. Lower the vehicle.