LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2008 >> Express 1500 AWD V8-5.3L >> Repair and Diagnosis >> Transmission and Drivetrain >> Automatic Transmission/Transaxle >> Service and Repair >> Overhaul >> 4L60-E/4L65-E/4L70-E Automatic Transmission >> Assemble, Disassemble, and Installation >> Reverse Input Clutch Bushing Replacement

Reverse Input Clutch Bushing Replacement



Reverse Input Clutch Bushing Replacement

Removal Procedure


Tools Required
* J 25019 Bushing Service Set
* J 34196-B Transmission Bushing Service Set
* J 7004-A Universal Remover
* J 8092 Driver Handle






1. Inspect the reverse input clutch housing and drum assembly for the following conditions:

* Damaged or worn bushings
* Surface finish on the hub and outer housing - check band surface for flatness
* Leak at the weld
* Heat distortion
* Rolled or distorted retaining ring groove





2. Using the J 25019-16 with the J 7004-A , remove the reverse input clutch front bushing (603).




3. Using the J 25019-4 with the J 8092 , remove the reverse input clutch rear bushing (606).



Installation Procedure





1. Using the J 25019-9 with the J 8092 , install a reverse input clutch front bushing (603).




2. Using the J 34196-3 which is part of kit J 34196-B with the J 8092 , install a reverse input clutch rear bushing (606).


scientia non olet · About LEMON Manuals