Vacuum Reservoir HVAC: Service and Repair

Vacuum Tank Replacement

Removal Procedure




1. Remove the primary battery tray.
2. Disconnect the vacuum hose from the vacuum tank.
3. Remove the screws (1) from the vacuum tank retainers.
4. Remove the vacuum tank (3) from the battery tray.

Installation Procedure




1. Install the vacuum tank (3).

Notice: Refer to Fastener Notice.

2. Install the screws (1) to the vacuum tank retainers.

Tighten the screws to 6 N.m (53 lb in).

3. Connect the vacuum hose.
4. Install the primary battery tray.