Air Temperature Door Replacement

Air Temperature Door Replacement

Removal Procedure

1. Remove the heater assembly.
2. Disconnect the air temperature actuator electrical connector.




3. Remove the air temperature actuator retaining screws.
4. Remove the air temperature actuator (1) from the heater assembly (2).




5. Remove the air temperature door (1) from the heater assembly.

Installation Procedure




1. Install the air temperature door (1) to the heater assembly.




2. Install the air temperature actuator (1) to the heater assembly (2).

Notice: Refer to Fastener Notice.

3. Install the air temperature actuator retaining screws.

Tighten screws to 1.9 N.m (17 lb in).

4. Connect the air temperature actuator electrical connector.
5. Install the heater assembly.