Temperature Valve Actuator Replacement - Auxiliary

Temperature Valve Actuator Replacement - Auxiliary

Removal Procedure

1. Remove the left rear quarter trim panel.
2. Disconnect the electrical connector from the air temperature actuator.
3. Remove the retaining screws from the air temperature actuator.




4. Remove the air temperature actuator.

Installation Procedure




1. Install the air temperature actuator.

Notice: Refer to Fastener Notice.

2. Install the retaining screws to the air temperature actuator.

Tighten the screws to 1.9 N.m (17 lb in).

3. Connect the air temperature electrical connector to the actuator.
4. Install the left rear quarter trim panel.