Diagnostic Fault Information

WARNING: This page is about a different variant/trim than selected.

The following fault table will help determine if a hydraulic circuit or an incorrect position of a valve train component affects the transmission operation.

Component	Cause	DTCs
Automatic Transmission Fluid Filter Assembly	Oil filter loose or damaged	P0796
Control Solenoid (w/body and TCM) Valve Assembly	Clutch Pressure Control Solenoid 3: Always exhausting (Stuck On) Not exhausting (Stuck Off) Needle piston or armature pin binding Control signal fluid supply leak - valve body filter plate assembly cracked or damaged gasket seal O-ring seals leaking Valve body Filter Plate Assembly cracked, blocked or damaged gasket seal	P0796 P0797
Lower Control Valve Body Assembly	Clutch Select Valve stuck off - debris, sediment, binding or scored bore	P0796 P0797
Fluid Pump Cover Assembly	Fluid pump cover vanes and fluid pump rotor broken - wrong pump rotor installed Fluid pump or torque converter overstressed because of high temperatures	P0796
1-2-3-4 and 3-5-R Clutch Housing Assembly	1-2-3-4 clutch backing plate retaining ring not seated, causing the piston to over-travel and cut 1-2-3-4 clutch piston seal	P0796
4-5-6 Clutch Housing	4-5-6 housing broken hub weld	P0796

Transmission Gear Range to PC Solenoid Valve Operation

Gear	1-2-3-4 CL PC SOL 5	2-6 CL PC SOL 4	3-5 REV CL PC SOL 2	LOW REV 4-5-6 CL PC SOL 3
Park	OFF	OFF	OFF	ON
Reverse	OFF	OFF	ON	ON
Neutral	OFF	OFF	OFF	ON
1st Braking	ON	OFF	OFF	ON
1st	ON	OFF	OFF	OFF
2nd	ON	ON	OFF	OFF
3rd	ON	OFF	ON	OFF
4th	ON	OFF	OFF	ON
5th	OFF	OFF	ON	ON
6th	OFF	ON	OFF	ON