Output Carrier Assembly Overhaul

Fig 1: Overhauling Output Carrier Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Output Carrier Front Sun Gear Thrust Bearing Assembly
2	Center Support Roller Bearing NOTE: Do not reuse the center support roller bearing. Install a NEW center support roller bearing. Reusing an old bearing may result in damage to the output carrier. Tip: The thick side of the bearing shell faces up. Special Tools DT 47857 Bearing Installer. See Special Tools . J 6125-B Slide Hammer. See Special Tools . J 8092 Driver Handle. See Special Tools . J 23129 Universal Seal Remover. See Special Tools .
3	Output Carrier Front Sun Gear NOTE: Install the gear chamfer side up. Failure to install the gear chamfer side up may result in transmission damage.
4	Output Carrier Front Sun Gear Rear Thrust Bearing Assembly
5	Output Carrier Rear Sun Gear NOTE: Install the gear chamfer side up. Failure to install the gear chamfer side up may result in transmission damage.
6	Output Carrier Rear Sun Gear Bearing Assembly Tip: Inspect for damage only. Do not remove. The bearing assembly is not a serviceable component.