Security Indicator LED Inoperative

Step	Action	Yes	No
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Arm the content theft system. Does the security indicator LED illuminate?	Go to Testing for Intermittent Conditions and Poor Connections	Go to Step 3
3	Turn OFF the ignition. Disconnect the body control module (BCM) connector containing the LED control circuit. With a fused jumper wire and appropriate terminal adapter, apply 12 volts to the security indicator control circuit. Does the security indicator LED illuminate?	Go to Step 6	Go to Step 4
4	Disconnect the security indicator LED. Probe the ground side of the security indicator control circuit with a test lamp connected to B+. Does the test lamp light?	Go to Step 5	Go to Step 8
5	Test the security indicator LED control circuit for an open or short to ground. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition?	Go to Step 11	Go to Step 7
6	Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 11	Go to Step 9
7	Inspect for poor connections at the harness connector of the security indicator LED. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 11	Go to Step 10
8	Repair the open in the security indicator control ground circuit. Refer to Wiring Repairs . Did you complete the repair?	Go to Step 11	-
9	Replace the BCM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 11	-
10	Replace the security indicator LED. Refer to LED Indicator Replacement - Vehicle Security System . Did you complete the replacement?	Go to Step 11	-
11	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3