Conditions for Clearing the DTC
The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.
| Step | Action | Yes | No |
|---|---|---|---|
|
CAUTION:
Refer to Sensing and Diagnostic Module Handling Caution
.
CAUTION:
Refer to Sensing and Diagnostic Module Voltage after Ignition is Turned Off Caution
. Schematic Reference: SIR Schematics Connector End View Reference: SIR Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 | Inspect the vehicle's charging system including the alternator. Is the charging system OK? |
Go to Step 4 | Go to Step 3 |
| 3 | Repair the charging system. Is the repair complete? |
Go to Step 5 | - |
| 4 |
|
Go to Step 5 | - |
| 5 |
|
Go to Step 2 | System OK |