LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Optra5 LT, Standard >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraints - DTC 052 To DTC 087 And DTC B1101 To DTC B1330 >> DTC 080 >> Conditions for Clearing the DTC

Conditions for Clearing the DTC

The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.

Step Action Values Yes No
CAUTION: Refer to Sensing and Diagnostic Module Voltage after Ignition is Turned Off Caution .
CAUTION: Refer to Sensing and Diagnostic Module Handling Caution .
Schematic Reference:  SIR Schematics Connector End View Reference:  SIR Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Confirm the ignition switch is OFF.
  2. Wait 1 minute for the sensing and diagnostic module (SDM) charger to be discharged.
  3. Visually inspect the air bag wiring and connector for any damage.
Is the air bag wiring damaged?		 - Go to Step 5  Go to Step 3 
3
  1. Disconnect the connector of the driver side air bag.
  2. Disconnect the connector of the SDM.
  3. Measure the resistance of the high and low circuits of the driver side impact sensor.
Is the resistance equal to the specified value?		 0 Ω Go to Step 4  Go to Step 5 
4 Measure the resistance between the high and low circuits of the driver side impact sensor and battery positive.
Is the resistance equal to the specified value?		 ∞ Go to Step 6  Go to Step 5 
5 Replace the air bag wiring.
Did you complete the replacement?		 - Go to Step 8  -
6
  1. Replace the driver side impact sensor. Refer to Inflatable Restraint Side Impact Sensor Replacement .
  2. Connect the negative battery cable.
  3. Use the scan tool in order to clear the DTCs.
  4. Perform the Diagnostic System Check - Vehicle .
Is DTC 080 still shown as a current fault?		 - Go to Step 7  Go to Step 8 
7 Replace the SDM. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement .
Did you complete the replacement?		 - Go to Step 8  -
8
  1. Reconnect all SIR components.
  2. Verify that all components, connectors and connector position assurances (CPAs) are properly mounted.
  3. Use the scan tool in order to clear the DTCs.
  4. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text.
Does the DTC reset?		 - Go to Step 2  System OK
scientia non olet · About LEMON Manuals