LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Optra5 LT, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Rear Brake Hose Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Brake Hose Retainer
    GM1289921Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Connect the brake pipe line to the brake hose.

    Tighten:  Tighten the brake line to 16 N.m (12 lb ft)  .

  2. Install the retainer onto the rear brake hose bracket from the wheel house.
    3. Fig 2: View Of Rear Disc Brake Hose-To-Caliper Bolt
    GM1289930Courtesy of GENERAL MOTORS CORP.
  3. Install the rear disc brake hose to the caliper.

    Tighten:  Tighten the rear disc brake hose-to-caliper bolt to 32 N.m (24 lb ft)  .

  4. Install the rear disc brake hose and retainer on the bracket on the steering knuckle shaft.
  5. Lower the vehicle.
  6. Bleed the brake system. Refer to Hydraulic Brake System Bleeding (ABS)  or Hydraulic Brake System Bleeding (Manual) .
  7. Inspect the brake system for leaks.
scientia non olet · About LEMON Manuals